The German Army ultimately settled on the Borchardt-based Luger design for its armed forces.1917 World War I German Luger Semi Automatic Pistol with holster. The famous Borchardt design and the Mauser C96 pistol are both examples of this interest at the turn of the century. The end of the 1890s and early 1900s saw great international military interest in semiautomatic weapons, particularly handguns. The Royal Government Arsenal at Erfurt only manufactured about 7,000 Model 1914 Lugers in 1914, by far the fewest number produced during Erfurt production during the war. Approximately 1,000 produced, 1 to 4 digit serial: Dutch Contract - produced 1936-1940 Military contract Caliber 9mm Parabellum - 4' barrel 1,000 produced, 4 digit serial: Mauser Banner Dated - produced 1936-1942 Unknown contract Caliber 9mm Parabellum - 4' barrel A few thousand produced, 1 to 5 digit serial with letter: Swedish Contract - produced 1938-1939This is a very rare and fine condition, all matching WWI German Model 1914 Luger manufactured by the Erfurt Arsenal in 1914, the first year of WWI.
Erfurt Luger S Serial Number 300 ToInitial Model of 1908 Lugers did not have chamber markings but the year of manufacture began to be marked on the chamber in 1910.The 8,000 range fits with the WW I Erfurt Military Serial number ranges for 1911 (from 575-9,548), It is a 9 MM parabellum, 4 inch barrel (dated 1910-1914). Although the German Army tested the Luger design as early as 1901, it did not officially adopt the Luger as the standard Army sidearm until August 1908, which gave the weapon the designation Model of 1908. The first German military organization to adopt the new Luger design was the German Navy, which approved the Model of 1906 pistol on May 12, 1905. Initial military production of the Luger pistol, in 9mm Parabellum caliber, was limited to the Deutsche Waffen und Munitionsfabriken (DWM). The Royal Government Arsenal at Erfurt manufactured about 175,000 Model 1914 Lugers in 1918, from serial number 300 to 7538t.The end of the 1890s and early 1900s saw great international military interest in semiautomatic weapons, particularly.The first Model 1908 Lugers were manufactured in early 1911 and Luger production continued through November 1918, when the last Erfurt-manufactured Lugers were produced. Funds for production was allocated on Januand tooling up for Luger production began. The Erfurt Arsenal was a Prussian government-owned arms factory that manufactured ammunition and rifles at Erfurt in Thuringen. ![]() In 1914, when this particular Erfurt Luger was manufactured, the serial number range ran from approximately 504 to 9448b. Approximately 453,000 Model 1914 Erfurt Lugers were manufactured. Approximately 7,000 Erfurt Lugers were manufactured with a 1914 date, of which this pistol is one, 80,000 with a 1916 date, 180,000 with a 1917 date and 175,000 with a 1918 date. With the stock lug and hold-open device now standard, the model was changed to the Model of 1914. The Barrel witness line at the rear lines up exactly with the witness line on the Receiver (also referred to as the Barrel Extension). The bottom of the Barrel is serial number matching and is marked "6902," over the muzzle diameter of the barrel at production in millimeters, "8,82." The bore still has a mirror finish on the lands with darkening grooves and the rifling is still very strong.The Front Sight is the standard fixed front sight that is staked in place to the front sight dovetail. The right rear of the barrel also has an additional barrel eagle proof mark. The left, rear of the barrel has the Erfurt crown proof mark. Download firefox quantum for macThe Chamber Date is crisply marked "1914," and the face of the chamber is very clean with wear and thinning of the bluing in this area. The Sear Bar Spring retains 90% of its slightly faded fire blued finish. This Luger has the correct unrelieved Sear Bar, which wasn’t changed to the relieved style at DWM and Erfurt until 1917, and it is serial number matching with "02," and an Erfurt acceptance stamp on the raised portion and it retains 95% of its blued finish. The bottom of the Frame, at the magazine well opening, is an Erfurt crown acceptance stamp on the bottom rail of the stock lug and another Erfurt crown acceptance stamp over a serif “3” stamp in the magazine floor plate lug recess.The Side Plate is serial number matching with "02" stamped on the outside adjacent to an Erfurt crown over gothic letter acceptance stamp and it retains 90% of its blued finish with wear noted on the high points. The left side of the Frame, just above the trigger guard, are several stamps a serif “H” stamp and two “3” assembly stamps.The bottom part of the Frame on both sides, which are obscured when the Grip Panels are installed, have numerous inspector marks including serif “1” and “4” stamps. The Recoil Spring remains in the white and the Recoil Spring Guide appears to retain virtually all of its original blued finish The Frame itself shows almost no evidence of any corrosion ever having been present, especially on the Frame sides under the Grip Panels. The bottom rear of the receiver has a serif “A” and “S” stamp and a “7” assembly stamp.The Frame retains 95% of its original blued finish. The bottom lug of the Receiver has an Erfurt crown acceptance stamp as well as a sans serif “C” assembler mark and a serif “N” and “2” stamp. The external portion of the ejector spring retains 90% of the original straw finish and has the Erfurt eagle acceptance stamped horizontally.The right side of the Receiver has all of the correct proof marks crisply stamped, including three Erfurt crown inspector/acceptance stamps (Crown over gothic “W,” crown over gothic “S,” and crown over gothic “B” as well as the large eagle German Army Proof Test mark. The internal surfaces of the Frame are correctly polished in the white.The Front Grip Strap retains 95% of its blued finish as does the Trigger Guard Bow with wear noted on the high points. The Lanyard Ring is fully secured at the rear. The only part missing on this Luger is the Holden Open device, which does not affect the functioning of the pistol.The Frame itself has the full matching serial number "6902/a" on the nose with an Erfurt crown acceptance stamp below it on the front of the trigger guard. The inside edge of the Side Plate has the assembly number “33,” which matches the corresponding spot on the frame. The Trigger/Sear Lever Arm also has an Erfurt crown acceptance stamp. The Safety Lever is serial number matched with "02" stamped on the top flat, an Erfurt crown acceptance stamp on the bottom, and it retains 90% of its straw finish. The Trigger Spring remains in the white.The Safety Bar is serial number matching with "02" and an Erfurt stamp on the front and it remains in the white. The Magazine Release Spring retains 80% of its now faded fire blue finish.The Trigger is serial number matching with "02" stamped on the top left side and an Erfurt crown acceptance stamp on the right side and it retains 95% of its straw finish with the balance worn to the white. The Magazine Well is polished on both the front and rear and is in fine condition with no pitting noted.The Magazine Release checkered button is still crisp and the right, flat side exhibits 60% of the original straw finish along with an Erfurt crown acceptance stamp. The right panel also has the matching partial serial number “02” and an Erfurt crown acceptance stamp on the inside as well as a pencil “69,” which are the beginning of the pistol’s serial number. The left panel has an Erfurt crown acceptance stamp and the matching partial serial number “02” on the inside. The Takedown Lever, also known as the Locking Bolt, retains 80% of its original straw finish and it is serial number matching with the serial number "02" and an Erfurt crown stamp stamped on the left side.Both matching Grip Panels are in fine condition with very minor wear on the checkered, exterior points towards the bottom and neither panel has any chips or cracks noted. The Breech Block Pin still retains the majority of its original fire blued finish. The face of the Breech Block is clean. Both Grip Panels fit perfectly along the Frame edges and the Panels are solid and do not move.The Breech Block has the matching serial number "01" on the left side below the German Army Test Eagle proof stamp and an Erfurt crown acceptance stamp on the right side and it retains 95% of its blued finish.
0 Comments
Leave a Reply. |
AuthorShelly ArchivesCategories |